škodaturkey.com
GARAJ => Üye Atölyesi => Konuyu başlatan: mygokhan - 15 Şubat 2010, 23:25:08
-
Tercümeye gerek yok sanırım.Fotoğraflar gayet açıklayıcı..:ok:
Step 1.
Your common garden exterior door handle in all its glory.
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008231.jpg)
Step2.
On the edge of the door you have two grommets (Fabia) or one (Octavia). Take the top one out and loosen the T20 torx screw inside a few turns (dont take out).
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008232.jpg)
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008233.jpg)
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008234.jpg)
Step3.
Now take the bottom one out. Inside here is another T20 screw. Its fairly recessed so you will need a fairly long narrow screwdriver. Take the handle in and and hold it in the open position slightly. Now undo the screw gently until you feel a small resistance, stop there. If you have wound it out the handle should hold in the open position.
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008235.jpg)
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008236.jpg)
Now with the handle in its locked position lever the lock cylinder out with a suitable trim lever so as not to damage the paint work. They are usually quite welll seated but it its not moving at all undo the top T20 screw a little bit more.
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008237.jpg)
With the cylinder out you can no see the bowden cable that connects the handle to the lock mech inside the door. Make a mental note of the position of the cable in its channel or even better dob a little bit of paint or tippex on the end.
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008238.jpg)
Pop the cable off
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008239.jpg)
Now slide the whole handle backwards a touch
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008241.jpg)
And the handle swings out
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008242.jpg)
Withdraw the handle and your done. The lock cover just pops off.
Resized to 75% (was 800 x 600) - Click image to enlarge(http://i34.photobucket.com/albums/d134/Techie_1976/Fabia%20door%20handle/26102008244.jpg)
Kaynak : briskoda
-
Yarın Hakan bunun direk uygulaması yapar hatta fityoya bile çeker yayınlar :hanz:
Evet söz şimdi Hakan'da :hanz:
-
Bunları soran olmazsa anlatmaya bile gerek yok, kardeşime söktürüyom ben :++: :++: :++:
-
:)sök sök sen, ondan sonra arabanın orasından burasından gacur gucur sesler gelirse görürsün:)
-
:)sök sök sen, ondan sonra arabanın orasından burasından gacur gucur sesler gelirse görürsün:)
:+1:
Söküp takmaya gelmez durduk yerde.Ama Böyle gördükçe Beni de dürtüyor.Koymayın şunları böle ya:hanz:
-
Sökmesi basitmi diye bakmak için kendimi zor tutuyorum :D
-
nası söktüğünü anladım ama niye söktüğüne bi anlam veremedim:D